Kupari-SFP-lähetin-vastaanotinmoduuli BlueOptics AGM734-10000S-BO Gigabit Ethernet

The BlueOptics AGM734-10000S-BO is a Copper SFP transceiver module for Gigabit Ethernet applications. It implements the SFP interface and provides a copper RJ45 connection for 1000BASE-T links, enabling data transmission over twisted-pair cabling up to typical copper distances. The module is compact and lightweight (approximately 20 g) and is designed to meet MSA-compliant electrical and mechanical specifications for plug-and-play use in compatible SFP host devices.

Advantages

This Copper SFP offers a compact form factor and standard SFP electrical interface for easy insertion into switches, routers or other SFP-capable equipment. Built and tested to MSA guidelines, the module is compatible with hardware platforms supporting 1000BASE-T SFPs and supports Gigabit Ethernet data rates. The silver housing and low weight simplify handling and installation, while quality component selection and factory testing help ensure stable operation in standard network environments.

Suitable for

• Connecting Gigabit Ethernet ports over Cat5e/Cat6 twisted-pair cabling
• Hot-swappable SFP slot upgrades in switches and routers
• Replacing or extending copper SFP connectivity in data centers and enterprise networks
• Short-range uplinks and access links within network racks and wiring closets

Key specifications

• Interface type: SFP (Small Form-factor Pluggable)
• Data rate: Gigabit Ethernet (1000BASE-T)
• Connector: RJ45 (copper, twisted-pair)
• Typical link distance: up to typical copper channel limits (depends on cable category and environment)
• Weight: approximately 0.02 kg
• Housing colour: silver
• MSA-compliant electrical and mechanical specifications

How to use

Power down the host device or follow the manufacturer’s hot-swap procedure, then insert the BlueOptics AGM734-10000S-BO into an available SFP slot until it latches. Connect a suitable Cat5e/Cat6 copper cable to the module’s RJ45 port and to the remote device. Configure the host interface for 1000BASE-T operation if required by the equipment, and verify link and speed status through the host device management interface or front-panel LEDs. If diagnostics are supported by the host, monitor link status and basic parameters via the device management tools.

Recommendations

Use certified twisted-pair cables (Cat5e or better) and confirm that the host device supports third-party 1000BASE-T SFP modules. For predictable performance, install the module in a clean SFP slot and avoid bending or stressing copper patch cables near the connector. Follow the host vendor guidelines for firmware and compatibility when deploying in critical network environments.