Kuparilähetin-vastaanotinmoduuli BlueOptics SFP-GE-COPER-BO 1250 Mbit/s

The BlueOptics SFP-GE-COPER-BO is a copper SFP transceiver module designed for gigabit network links with a maximum data transfer rate of 1250 Mbit/s. Housed in a metal casing and operating from a 3.3 V input, this compact module weighs approximately 3 g and presents a silver finish. It uses the SFP interface and provides a standard RJ45 copper connection for easy integration into switches, routers and other network equipment that support SFP copper modules.

Advantages

The module combines a compact metal housing with low weight for simple installation and reliable mechanical protection. With support for up to 1250 Mbit/s over standard twisted-pair cabling and a 3.3 V supply it meets common SFP electrical and mechanical requirements. The SFP form factor ensures wide interoperability with devices that accept SFP transceivers, while the copper RJ45 interface allows the use of existing copper infrastructure without optical cabling.

Suitable for

Key specifications

How to use

Insert the SFP-GE-COPER-BO into an available SFP slot on compatible network equipment while the device is powered down or following the manufacturer's hot-swap guidance. Connect standard Cat5e/Cat6 twisted-pair cable to the module's RJ45 port and verify link status on the host device. Ensure the host device firmware or software supports third-party SFP copper transceivers if required for full compatibility. Monitor the port status through the switch or router management interface and perform firmware updates on the host equipment as recommended.

Recommendations

For reliable operation, use quality twisted-pair cables (Cat5e or higher) and keep copper link distances within 100 meters. Confirm compatibility with the target hardware and, if available, enable any digital diagnostic or monitoring features supported by the host device to aid troubleshooting and maintenance.