LED-nauha EUROLITE 800 5m 2835 1800–3000K DTW 24V

Flexible LED strip EUROLITE 800, 5 meters long, with high-density 2835 SMD LEDs and tunable white range from 1800 K to 3000 K (DTW). Designed for 24 V systems, this LED strip delivers continuous, even illumination for accent, ambient and task lighting. The tunable white spectrum lets you set very warm candle-like tones up to warm-neutral light, making it suitable for mood enhancement, display lighting and functional work areas. Its flexible construction allows installation in aluminum profiles, recessed channels or directly onto clean, flat surfaces.

Advantages

The EUROLITE 800 strip combines high LED density with a wide tunable white range, providing smooth color temperature transitions and consistent luminous output across the 5 m length. Operating at 24 V reduces voltage drop over longer runs and supports safer, low-voltage installations. Its 2835 SMD chips offer good luminous efficacy and long operating life, while the narrow form factor enables discreet mounting in narrow profiles and under cabinets. The strip is suitable for continuous runs and can be cut at designated intervals to fit custom lengths.

Suitable for

Key specifications

How to use

Measure the installation run and cut the LED strip only at the marked cut points. Prepare a compatible 24 V power supply and controller that supports tunable white (DTW) operation for adjusting color temperature between 1800 K and 3000 K. Clean the mounting surface to remove dust and grease, then attach the strip using the adhesive backing or place it into an aluminum profile for better heat dissipation and a finished appearance. Connect the strip to the controller and power supply observing polarity and any control wiring specifications, then test the strip at low settings before final sealing or profile assembly.

Recommendations

For best lifetime and stable light output, install the strip on an aluminum profile or another heat-dissipating surface and avoid tight bends. Use a sufficiently rated 24 V power supply with appropriate wattage margin for the entire run, and choose a DTW-capable controller to access the full 1800–3000 K range. If multiple runs are required, feed power at intervals to minimize voltage drop and ensure uniform brightness.