LED-neonflex-nauha EUROLITE 230V ohut RGB 100 cm, malli 50499801

EUROLITE 230V Slim RGB LED neon flex strip (100 cm) is a flexible, low-profile LED lighting solution designed for decorative and accent illumination. The 100 cm length and slim profile enable installation in narrow channels and along architectural contours. It connects directly to 230V mains power and provides red, green and blue color mixing to create a wide range of colors and dynamic lighting effects for indoor and protected outdoor applications.

Advantages

The slim design allows fitting into tight spaces where traditional rigid neon or bulky LED profiles would not be suitable. Direct 230V operation eliminates the need for bulky low-voltage drivers and simplifies installation when a compatible mains supply is available. RGB color mixing offers flexible color control for ambient lighting, signage accents and decorative outlines. The flexible housing is suitable for curved runs and details, and the product is intended for protected outdoor use where exposure to direct weather is limited.

Suitable for

Key specifications

How to use

Measure and prepare the installation route, ensuring the surface is clean, dry and suitable for mounting a slim flexible strip. Verify that the installation point provides safe access to a 230V mains connection and follow local electrical regulations. Cut or shorten the strip only at designated cutting points if applicable and use compatible end caps and mounting clips designed for slim neon flex profiles. Connect the strip to the mains supply using a suitable connector or terminal block; if unsure, use a qualified electrician. For color control and dynamic effects, pair the strip with an RGB controller compatible with 230V LED neon flex systems.

Recommendations

Install in locations protected from direct rain and prolonged moisture exposure; use weather-protective channels if an exposed outdoor placement is necessary. Ensure proper strain relief at the power connection and avoid sharp bends below the manufacturer’s minimum bend radius to maintain product life and consistent light output.