Leikkuri FEIN 63502227210

The Cutter FEIN 63502227210 is a multifunction tool attachment designed for precise cutting of plasterboard, plastic and wood. Its compact cutting blade measures approximately 55 mm in length and 35 mm in width, providing a balance between reach and control for detailed trimming and flush cutting tasks. Supplied as a single piece per pack, the cutter is intended for use with compatible oscillating multifunction tools to perform fine, straight and curved cuts in a range of common building and renovation materials.

Advantages

This cutter offers accurate edge control and a compact profile for access into narrow spaces and tight corners. The blade geometry supports smooth cutting action across plasterboard, plastic and timber while minimising tearing and chipping. Its universal attachment format simplifies mounting and replacement on many oscillating tools, reducing downtime during projects.

Suitable for

• Cutting openings and trims in plasterboard panels
• Shaping and trimming plastic components and pipes
• Detail cuts and notches in soft and hardwoods
• Access cuts in confined or hard-to-reach areas

Key specifications

• Cutting blade length: 55 mm (approx.)
• Blade width: 35 mm (approx.)
• Material compatibility: plasterboard, various plastics, wood
• Pack contents: 1 cutter attachment
• Designed for use with oscillating multifunction tools

How to use

Fit the cutter to a compatible oscillating multifunction tool following the tool manufacturer's instructions, ensuring the attachment is securely fastened before operation. Mark the cut line on the workpiece and start the tool at a moderate speed to create an initial guide. Proceed with steady, controlled movements, applying light pressure and allowing the oscillating motion to perform the cut. For curved cuts, move the tool slowly and change the blade angle as needed. After use, disconnect power and remove the cutter for inspection or replacement if wear is visible.

Recommendations

Use appropriate personal protective equipment such as safety glasses, gloves and a dust mask when cutting plasterboard, plastic or wood. Match blade selection and tool speed to the material being cut to reduce wear and obtain cleaner edges. Inspect the cutter regularly and replace it when performance diminishes to maintain cut quality and safe operation.