Lindy 0,3m RJ45 S/FTP LSZH kaapeli, valkoinen

Twisted Pair patch cable with RJ45 connectors using Cat.6A connectors on a Cat.7 S/FTP (600 MHz) LSZH cable. The 0.3 m Lindy patch lead combines full braided and individual foil shielding (S/FTP) with gold-plated contacts and an integrated snagless strain relief to support Ethernet links up to 10GBase-T in data centres, server rooms and rack-mounted network cabinets.

Advantages

The cable construction (Cat.7 S/FTP) provides enhanced protection against electromagnetic interference and crosstalk while the Cat.6A RJ45 connectors permit plug-and-play compatibility with standard Ethernet ports. Gold-plated pins reduce oxidation and signal loss for long-term reliable connections. The integrated snagless design protects the connector latch during installation and removal. The LSZH outer jacket minimises hazardous smoke in case of fire and the product is manufactured and tested to ISO/IEC 11801 standards.

Suitable for

• High-speed Ethernet up to 10GBase-T
• Connections in data centres and server rooms
• Rack-mounted network and control cabinets
• Tight installation spaces and short patch runs (0.3 m)

Key specifications

• Cable type: Cat.7 S/FTP (braided shielding + individual foil)
• Connector type: RJ45 Cat.6A (gold-plated contacts)
• Bandwidth: up to 600 MHz
• Length: 0.3 m
• Jacket: LSZH (Low Smoke Zero Halogen)
• Standards: manufactured and tested to ISO/IEC 11801
• Colours available: White (this item), also Black, Blue, Grey, Red
• Warranty: 10 years

How to use

Plug one RJ45 connector into the network port of your device and the other into the switch, patch panel or wall socket. Ensure connectors are fully inserted until the latch clicks to secure the connection. Use the 0.3 m length for short patching between adjacent ports or within crowded racks where minimal cable slack is required. Avoid sharp bends and maintain recommended bend radius to preserve shielding and performance.

Recommendations

For best performance, use this Cat.7 S/FTP LSZH patch cable when upgrading to or operating 10GBase-T networks in controlled environments such as server rooms and data centres. Inspect connectors for damage before installation and route cables to avoid interference from power sources; do not exceed the specified bend radius.