Lindy 47736 verkkokaapeli punainen 5 m Cat6 S/FTP (S-STP)

The Lindy Cat.6 S/FTP RJ-45 Cat6 5m Red is a 5-metre network patch cable built to support Gigabit Ethernet and shielded to reduce electromagnetic interference. It comes terminated with RJ-45 connectors featuring gold-plated contacts for reliable signal transfer and corrosion resistance. The cable’s S/FTP construction (shielded foil twisted pairs plus overall braid) and Category 6 specification make it suitable for stable high-speed data transmission in structured cabling environments, while the red jacket provides visible identification in patch panels and network closets.

Advantages

S/FTP shielding minimises crosstalk and external electromagnetic interference, improving signal integrity over the full 5 m length. Gold-plated RJ-45 contacts ensure consistent connectivity and lower contact resistance, which helps maintain performance in frequent plug/unplug scenarios. The Cat6 rating supports 10/100/1000Base-T(X) networks, offering reliable bandwidth for common office and home applications. The red outer jacket aids cable management and rapid visual identification among multiple runs.

Suitable for

• Wiring between switches, patch panels and wall sockets within offices and data racks
• Home and small office Gigabit Ethernet connections
• Temporary or permanent networking setups where shielded cabling is required
• Situations where cable colour coding improves organisation and troubleshooting

Key specifications

• Length: 5 m
• Connector type: RJ-45 to RJ-45
• Cabling standard: Category 6 (Cat6)
• Shielding: S/FTP (foil individual pairs with overall braid)
• Supported speeds: 10/100/1000 Mbps (Gigabit Ethernet)
• Outer colour: Red

How to use

Connect one RJ-45 plug to your network device (switch, router, network interface) and the other plug to the corresponding port on the second device or patch panel. Ensure connectors are fully seated until the latch clicks. Route the cable to avoid sharp bends and place it away from high-power electrical sources to reduce potential interference. For rack or patch-panel installations, use appropriate cable management accessories to maintain bend radius and prevent strain on the connectors.

Recommendations

For best performance, use within recommended environmental conditions and avoid stretching or kinking the cable. When installing in electrically noisy environments, verify that both ends are properly grounded through the shielded ports or chassis to maximise the S/FTP shielding effectiveness.