Microconnect B-UTP605G verkkokaapeli vihreä 5 m Cat6 U/UTP (UTP)

The Microconnect B-UTP605G RJ-45 Cat6 5m in green is a 5‑metre U/UTP Cat6 patch cable with RJ-45 connectors at both ends. It supports data rates up to 10,000 Mbit/s and is designed for connecting network devices such as switches, modems and routers to each other or to structured cabling via patch panels, keystone jacks or wall outlets. The cable is backwards compatible with Cat5e and Cat5 and is tested to the Cat6 frequency of 250 MHz. Latch protection on the connectors reduces the risk of damage during installation in confined spaces.

Advantages

The cable provides Cat6 performance with U/UTP construction for reduced electromagnetic interference while remaining compatible with older standards. Its 5 m length suits typical workstation and small office connections, and the pre‑fitted RJ-45 connectors simplify installation. The green colour helps with cable identification in complex installations and the latch protection helps prevent connector damage when routing through tight openings.

Suitable for

• Connecting switches, routers and modems to patch panels or wall outlets
• Small office and home network connections
• PCs, NAS units and networked entertainment devices
• Cabling runs where visual identification is useful

Key specifications

• Standard: Cat6, tested to 250 MHz
• Data rate: up to 10,000 Mbit/s
• Length: 5 m
• Connectors: RJ-45 — both ends
• Shielding: U/UTP
• Colour: Green
• Weight: 0.02 kg
• MPN: B-UTP605G, EAN: 5711045266317

How to use

Plug one RJ-45 connector into the network device (switch, router, modem) and the other into the target device or infrastructure outlet. Ensure connectors click into place and that the cable is not bent sharply near the ends. When routing the cable through panels or conduits, use the latch protection to avoid damaging the plug clip.

Recommendations

For optimal performance, avoid running the cable parallel and close to high‑voltage power lines or large motors. Use appropriate cable management to prevent strain at connector ends and replace the cable if the connector latch or jacket becomes damaged.