Microconnect UTP620G verkkokaapeli vihreä 20 m Cat6 U/UTP (UTP)

The Microconnect UTP620G is a 20 m Cat6 U/UTP networking cable with RJ-45 connectors on both ends. Designed for connecting switches, modems, routers or patch panels, this cable supports data transfer rates up to 10000 Mbit/s and meets the Cat6 standard with testing up to 250 MHz. Its green jacket and latch protection on the connectors help maintain reliable physical connections in home, office and entertainment networks.

Advantages

The cable is Cat6-rated and backward compatible with Cat5e and Cat5, offering tested performance up to 250 MHz. It features RJ-45 connectors on both ends and latch protection to reduce the risk of connector damage during installation. With a 20 m length and U/UTP construction, it provides a balance of reach and signal integrity for typical small office and home network setups.

Suitable for

• Connecting switches, routers and modems
• Patch panel and keystone jack installations
• Home networks and small office LANs
• Entertainment systems and media streaming setups

Key specifications

• Manufacturer: MicroConnect
• Model / MPN: UTP620G
• Length: 20 m
• Standard: Cat6 (tested up to 250 MHz)
• Maximum data rate: up to 10000 Mbit/s
• Connectors: RJ-45 to RJ-45
• Shielding: U/UTP
• Colour: Green
• Weight: 0.74 kg
• EAN: 5705965922910

How to use

Connect one RJ-45 connector to your network device (switch, router or modem) and the other RJ-45 connector to the destination device, patch panel or wall outlet. Ensure connectors fully seat until the latch clicks to secure the connection. Route the cable without sharp bends or pinch points and avoid running parallel and close to sources of strong electrical interference for best performance.

Recommendations

For reliable Cat6 performance, use this cable within standard installation practices: avoid extreme bends, keep separation from high-voltage cables, and test connections after installation. For structured cabling runs consider using appropriate cable management and patch panels to maintain signal integrity.