Naulain- ja nitojalisävaruste DeWALT DCN8901055 510 naulaa 5,5 cm

The DeWALT DCN8901055 accessory pack contains 510 nails, each 5.5 cm long, intended for use with compatible DeWALT nailers and staple guns. This supply is created to support continuous fastening work in construction, carpentry and finishing tasks where a high count of nails is required. The nails are sized for medium-length fastening applications and are presented in a format that facilitates loading and reduces downtime on the worksite.

Advantages

The nails offer consistent length and form to ensure uniform driving depth and reliable holding power in typical framing and trim materials. Supplied in a bulk count of 510, the pack reduces the frequency of reloads and supports extended work periods without interruption. Designed to match the tool’s feeding mechanism, these nails help maintain smooth operation and reduce misfeeds when used with compatible DeWALT nailers and staple guns.

Suitable for

• General carpentry and framing work
• Interior trim and moulding installation
• Subfloor and decking fastening where medium-length nails are required
• Contractor and professional renovation tasks needing bulk fasteners

Key specifications

• Quantity: 510 nails per pack
• Nail length: 5.5 cm
• Compatibility: designed for use with compatible DeWALT nailers and staple guns (confirm model compatibility before use)
• Intended application: medium-length fastening for wood and composite materials

How to use

Before loading nails, ensure the nailer or staple gun is disconnected from power or the battery is removed. Open the tool’s magazine according to the tool manufacturer’s instructions, and insert the strip or coil as required by the specific model. After loading, check alignment and perform a few test drives into scrap material to confirm correct seating depth and tool settings. Maintain proper personal protective equipment such as eye protection and follow standard safety procedures while operating the tool.

Recommendations

Confirm tool compatibility with the 5.5 cm nail length and the magazine feed type prior to purchase. Store the nails in a dry place to prevent corrosion and handle them with care to avoid injury. When working with dense or treated lumber, adjust driving power or use pilot holes as recommended for the specific material to achieve optimal holding and prevent splitting.