Palloventtiili Barrow TLQFS-V1 s s 10 mm G1/4 hopea – sulkuventtiili nestjäähdytykseen

The Barrow TLQFS-V1 s s 10mm G1/4 silver is a compact ball shut-off valve engineered for liquid cooling loops and small fluid circuits. Designed for inline installation, the valve provides a simple mechanical solution for stopping or allowing flow in PC water-cooling systems and other low-pressure liquid-handling setups. The silver finish and G1/4 threaded fittings make it compatible with common fittings and tubing standards used in enthusiast and custom cooling builds.

Advantages

The valve offers a 10 mm bore for unobstructed flow and a robust ball mechanism that enables quick shut-off with a clear open/closed position. G1/4 threaded connections ensure broad compatibility with common cooling system fittings. The silver finish provides corrosion resistance and a neutral appearance for integration into a range of build styles. Inline configuration permits insertion at convenient points in a loop without requiring major rework of existing tubing runs.

Suitable for

• PC water-cooling systems for isolating radiators, pumps, or reservoirs
• Small fluid circuits and test rigs requiring manual shut-off
• Maintenance and leak isolation tasks during system upgrades or component swaps

Key specifications

• Bore diameter: 10 mm
• Thread type: G1/4 (female/male fittings dependent on installation)
• Material finish: silver
• Mounting style: inline
• Operation: manual ball valve with quarter-turn action

How to use

Install the valve inline between two sections of tubing or between tubing and a component using compatible G1/4 fittings. Ensure all system fluid has been drained or isolated before disconnecting lines. Tighten threaded fittings to a secure, hand-plus-quarter-turn fit and check alignment of the valve handle to confirm the open and closed positions. Operate the valve with a single quarter-turn to open or close the flow; avoid excessive force when turning to preserve the seal and internal ball seating.

Recommendations

Before first use, perform a pressure- and leak-test of the loop at low pressure to confirm sealing. For maintenance, close the valve to isolate downstream components and slowly drain fluid to prevent spills. Use compatible corrosion-inhibited coolant and avoid abrasive particles that can wear internal seals. Periodically inspect threads and sealing surfaces for signs of wear or contamination and re-tighten fittings as necessary after initial thermal cycling.