Power-Lock-kaapeli MicroConnect MC-C13C14LOCK-2MW — IEC C13 C14, 2 m, lukitusliitin

MicroConnect MC-C13C14LOCK-2MW is a 2 metre power cable with an IEC C13 connector on one end and an IEC C14 connector on the other, featuring a locking mechanism on the connector(s) to reduce the risk of accidental disconnection. It is intended to provide a steady AC connection between IT equipment and power distribution units, servers or other compatible devices in rack-mounted and professional environments where continuous power delivery is required.

Advantages

The locking connector design increases connection security and helps prevent inadvertent unplugging during maintenance or equipment movement. At 2 m length the cable offers flexibility for routing inside racks and cabinets while keeping a tidy installation. The cable is compatible with standard IEC C13 and C14 power inlets commonly used on servers, network switches and workstations, enabling straightforward replacement or upgrade of existing power leads.

Suitable for

• Rack-mounted servers and blade enclosures
• Power distribution units (PDUs) in data cabinets
• Network switches and active network equipment
• Workstations and desktop systems with IEC inlets

Key specifications

• Connector type: IEC C13 to IEC C14
• Locking mechanism on connector(s) to prevent accidental disconnection
• Length: 2 metres
• Application: AC power connection for IT and network equipment

How to use

Insert the IEC C14 end into the power inlet of the power source or PDU and plug the IEC C13 end into the device's power inlet. Ensure the locking mechanism engages according to the connector design so the connection is secured. Route the cable to avoid sharp bends and mechanical stress, and confirm both ends are properly seated before powering equipment.

Recommendations

Use the MicroConnect locking power cable in environments where accidental disconnection would cause disruption. Check compatibility with the device inlet type before installation, and periodically inspect the locking mechanism and cable for wear. Replace the cable if any damage to the connectors or insulation is observed.