QSFP28 lähetin-vastaanotin BlueOptics QSFP28-100G-SR4-MP-BO 100G 100000 Mbit/s

The BlueOptics QSFP28-100G-SR4-MP-BO is a 100G fiber optic transceiver module with a QSFP28 interface designed for high-speed multi-mode fiber links. Housed in a metal casing and weighing approximately 40 g, it supports data rates up to 100000 Mbit/s and uses an MTP/MPO connector to transmit and receive optical signals at 850 nm over distances up to 100 m. The module conforms to MSA form-factor and interoperates with hardware platforms that accept QSFP28 100GBASE-SR4 transceivers.

Advantages

This transceiver provides a compact QSFP28 footprint for 100G connectivity while offering a robust metal housing and a low weight for easy handling and installation. Compliance with MSA standards and usage of high-quality optical and electronic components ensures stable signal transmission, compatibility with major networking hardware, and extended operational lifetime. Built-in digital diagnostics (DDM/DOM) enable real-time monitoring of parameters such as temperature, supply voltage and optical power for simplified maintenance and troubleshooting.

Suitable for

Key specifications

How to use

Install the BlueOptics QSFP28-100G-SR4-MP-BO into a compatible QSFP28 port on network equipment following the vendor’s hot-plug procedures. Connect an appropriate MPO/MTP multi-mode fiber patch cord to the transceiver and route it to the corresponding port or patch panel. Ensure the connected device supports 100GBASE-SR4 and the DDM/DOM function if diagnostics are required. Verify link status and monitor diagnostic parameters through the host device firmware or management interface.

Recommendations

For optimal performance, use high-quality OM3/OM4 multi-mode fiber and MPO/MTP patch cords rated for 100 Gbit/s. Verify compatibility with the target hardware and firmware, enable DDM/DOM monitoring where available, and avoid excessive bending or stress on the fiber connections to maintain signal integrity and long-term reliability.