S/FTP-patchkaapeli VALUE Cat.6 halogeeniton harmaa 2 m

VALUE S/FTP Patch Cord Cat.6 halogen-free grey 2 m is a 2‑metre shielded twisted pair patch cable with RJ‑45 connectors on both ends, designed for use as a patch cable in wiring cabinets or as a direct device-to-device connection. The cable has an S/FTP construction with braided shield, stranded copper conductors (8 wires) and a 100 Ω impedance. The jacket is LSOH (Low Smoke Zero Halogen), which limits smoke emission and contains no halogens when exposed to high heat. The connector wiring follows 1:1 contact settings according to EIA/TIA 568 standards. Laboratory tests performed by the manufacturer confirmed compliance with Class E specifications for a 100 m channel when used with compatible components.

Advantages

The S/FTP shielding and braided shield provide improved protection against electromagnetic interference compared with unshielded cables, while the stranded copper conductors and flexible LSOH jacket allow for narrow bending and easy routing in confined spaces. Halogen‑free jacketing reduces toxic gas and corrosive residues in the event of fire. Standard RJ‑45 connectors and EIA/TIA 568 1:1 contact wiring ensure broad compatibility with network equipment.

Suitable for

• Patch connections in network cabinets and distribution frames
• Direct device-to-device connections (switch to switch, switch to workstation)
• Installations requiring flexible cabling routed through tight spaces
• Environments where halogen‑free materials are preferred for safety

Key specifications

• Brand: VALUE
• Model / MPN: 21.99.0702
• EAN: 7611990113880
• Type: S/FTP Cat.6 patch cord
• Length: 2 m
• Connectors: RJ‑45 — both ends, 1:1 wiring (EIA/TIA 568)
• Conductors: 8 stranded copper wires
• Shielding: S/FTP with braided shield
• Impedance: 100 Ω
• Jacket: LSOH (Low Smoke Zero Halogen)

How to use

Connect one RJ‑45 plug to the network device or patch panel port and the other plug to the corresponding port on the second device or patch panel. Ensure that both ends are fully inserted until the connector latch clicks. Route the cable without sharp bends and avoid excessive tensile load. For structured cabling channels longer than the patch cord length, use compatible solid‑wire in‑wall or cabinet components rated for Cat.6 to maintain Class E performance.

Recommendations

For best results in a structured cabling system, pair this VALUE S/FTP patch cord with Cat.6 S/FTP solid cables, shielded wall jacks and shielded patch panels rated for Cat.6 (examples: ROLINE Cat.6 S/FTP Solid LSOH and VALUE Cat.6 shielded wall jack / 19" shielded patch panel). Avoid routing this patch cord near high‑power electrical cables to minimise interference.