SFP-lähetin-vastaanotin BlueOptics H-BR40A-SFP+U-BO 10000 Mbit/s kuitu

The BlueOptics H-BR40A-SFP+U-BO is an SFP+ fiber optic transceiver module designed for 10 Gbit/s class connections. Housed in a robust metal casing and weighing approximately 20 g, this SFP+ module supports a maximum data transfer rate of 10000 Mbit/s and an operational input voltage of 3.3 V. With an SFP+ interface and silver housing, it is intended for use in common networking equipment that accepts MSA‑compliant SFP+ transceivers and for fiber links that require single‑module plug‑in connectivity.

Advantages

The transceiver combines a compact metal housing with a lightweight design that eases installation in dense switch or router ports while providing mechanical protection and thermal dissipation. A maximum transfer distance of 40,000 m gives the module the ability to serve both short- and long-reach fiber links depending on the connected fiber type and network design. Standard SFP+ form factor and 3.3 V operation ensure compatibility with a wide range of modern network devices that support SFP+ optical modules.

Suitable for

Key specifications

How to use

Install the BlueOptics H-BR40A-SFP+U-BO by inserting the module into a compatible SFP+ port until it clicks into place. Connect the appropriate fiber optic cable to the transceiver connector, ensuring correct polarity and clean, undamaged fiber endfaces. Power and link status are managed by the host device; verify link lights and device diagnostics after insertion. When removing the module, release any retention mechanism on the host and gently pull the transceiver straight out to avoid damaging the port.

Recommendations

Use factory‑tested, MSA‑compliant SFP+ ports and matched fiber patch cables to achieve the specified range and performance. Keep transceiver endfaces covered when not connected and clean connectors before mating. For long-distance links, verify that the fiber type, attenuation and any intermediate components (patch panels, splices) meet the required optical budget. Check host device compatibility and firmware requirements where vendor lockdown of third‑party modules may apply.