SFP+ lähetin-vastaanotin BlueOptics SFP+KT-50SR-BO 10000 Mbit/s 850 nm

The BlueOptics SFP+KT-50SR-BO is a 10G SFP+ fiber optic transceiver module designed for short-range multimode links. It supports a maximum data transfer rate of 10000 Mbit/s and operates at a wavelength of 850 nm. The module uses an SFP+ interface with LC Duplex connection and includes Digital Diagnostics Monitoring (DDM/DOM) compliant with MSA SFF-8472 to provide real-time status of supply voltage, temperature, laser bias current and optical power levels. Constructed to MSA standards and built from high-quality optical and electronic components, this transceiver suits common networking hardware platforms and is CE, FCC and RoHS compliant with an MTBF of approximately 3,000,000 hours.

Advantages

The transceiver offers 10 Gbit/s performance for short-reach multimode fiber links with a standardized SFP+ form factor for broad compatibility. Integrated digital diagnostics enable remote monitoring and easier troubleshooting. Components selected from established suppliers and adherence to MSA specifications contribute to predictable interoperability and extended service life. The compact LC Duplex connector and silver housing support straightforward installation and reliable optical connections in dense networking environments.

Suitable for

Key specifications

How to use

Insert the SFP+ transceiver into a compatible SFP+ port on your network device until it latches. Connect LC Duplex multimode fiber patch cables matching the transceiver’s connector to the remote transceiver or patch panel, ensuring proper polarity for transmit and receive lanes. If available, enable or verify DDM/DOM support on the host device to monitor real-time diagnostics such as optical power and temperature. Follow the hardware vendor’s instructions for hot-plugging and for any required firmware or compatibility settings on the switch, router or storage system.

Recommendations

Use OM3/OM4 multimode fiber for optimal reach and performance at 10 Gbit/s, avoid bending the fiber beyond manufacturer bend-radius limits, and ensure clean LC connector end-faces before mating. Verify that the host hardware supports third-party SFP+ modules and DDM/DOM if you intend to use diagnostic features.