SFP-lähetin-vastaanotinmoduuli BlueOptics 10G-ER-SFP40KM-ET-BO 10000 Mbit/s

The BlueOptics 10G-ER-SFP40KM-ET-BO is an SFP+ fiber optic transceiver module designed for 10 Gigabit Ethernet links. It supports a maximum data transfer rate of 10,000 Mbit/s and is intended for long-distance single-mode fiber connections up to 40,000 m. The module has an LC fiber connector, a compact SFP+ form factor and a silver housing with a lightweight construction of approximately 20 g. Built with a high mean time between failures (MTBF) rating, it is suitable for installation in switches, routers and media converters that accept SFP+ optics.

Advantages

The module provides high-speed 10 Gigabit Ethernet performance over long distances while maintaining a compact SFP+ footprint compatible with standard optical ports. Its LC connector and single-mode design enable low-loss connections for backbone and campus links. With an MTBF of 1,000,000 hours and a lightweight silver metal casing, the transceiver is engineered for stable operation and straightforward handling during installation and maintenance.

Suitable for

• Long-distance 10 Gigabit Ethernet links over single-mode fiber
• Interconnecting core and aggregation switches in campus or data center environments
• Upgrading compatible network devices that accept SFP+ transceivers
• Use with media converters and fiber-optic uplinks requiring LC connectors

Key specifications

• Data transfer rate: 10,000 Mbit/s (10 Gigabit Ethernet)
• Maximum transfer distance: 40,000 m (single-mode fiber)
• Connector type: LC fiber connector
• Form factor: SFP+ (SFP transceiver module)
• Weight: approximately 0.02 kg
• Housing color: silver
• Reliability: MTBF around 1,000,000 hours

How to use

Install the BlueOptics SFP+ module into any compatible SFP+ slot on your network device according to the device manufacturer's instructions. Ensure the module is fully seated and the retaining mechanism is engaged. Connect the LC-terminated single-mode fiber patch cable to the transceiver's LC port, observing correct transmit/receive orientation. After physical installation, verify link status and configure the device's interface settings for 10 Gigabit Ethernet operation if required. Follow standard electrostatic discharge (ESD) precautions when handling the module.

Recommendations

Use factory-tested single-mode fiber and quality LC patch cables to achieve the specified reach. Verify compatibility with the host device firmware and optics compatibility lists before deployment. For stable long-distance links, monitor link parameters and maintain clean fiber endfaces to prevent signal loss.