SFP-lähetin-vastaanotinmoduuli BlueOptics 1286710000-BO 1250 Mbit/s kuitu

The BlueOptics 1286710000-BO SFP transceiver module is a compact fiber optic transceiver designed for 1.25 Gigabit Ethernet links. Supporting a maximum data transfer rate of 1250 Mbit/s and a maximum optical reach of up to 2000 m, this SFP module fits standard SFP slots and provides a lightweight, low-profile solution for optical network uplinks and media conversion. The module features an LC fiber connector and a silver housing, and its mean time between failures (MTBF) of 1,000,000 hours indicates long-term operational reliability.

Advantages

The transceiver offers a small SFP form factor that simplifies installation into switches, routers or media converters while occupying minimal rack space. With a maximum transfer distance of 2000 m over single-mode or compatible fiber, it supports medium-range optical links. Its 1250 Mbit/s throughput and 1.25 Gigabit Ethernet interface ensure compatibility with common network equipment. The lightweight silver module (approximately 20 g) is easy to handle and install, and the high MTBF contributes to stable network operation and reduced maintenance frequency.

Suitable for

• Optical uplinks between switches and routers within campus or data center networks
• Media conversion installations where SFP fiber connectivity is required
• Replacing or upgrading existing SFP transceivers in managed and unmanaged network devices
• Extending Ethernet segments over fiber up to 2000 m

Key specifications

• Maximum data transfer rate: 1250 Mbit/s
• Maximum transfer distance: 2000 m
• Ethernet interface type: 1.25 Gigabit Ethernet
• Fiber optic connector: LC
• Form factor: SFP (small form-factor pluggable)
• Product colour: Silver
• Weight: 0.02 kg
• Reliability: MTBF 1,000,000 hours

How to use

Ensure the host device supports SFP transceivers and that the optical fibre and connector type match the module's LC interface. Power off the equipment if recommended by the device manufacturer, align the module with the SFP slot and insert it until it locks in place. Connect the LC-terminated fiber patch cable to the module and to the remote device, observing proper transmit/receive orientation. After installation, verify link status and network configuration on the connected network device, and perform any necessary speed/duplex or interface settings as required.

Recommendations

Handle the module by its housing, avoid touching the optical connector end face, and keep protective dust caps in place when not connected. Use compatible LC fiber patch cables and verify connector cleanliness before mating to prevent signal loss. Install in environments that meet the host device’s operating specifications and observe electrostatic discharge precautions during handling and installation.