SFP-lähetin-vastaanotinmoduuli BlueOptics 3HE00062CB-BO kupari 1250 Mbit/s

The BlueOptics 3HE00062CB-BO Copper SFP transceiver module is a compact interface module designed for network equipment that supports SFP form factor connections. It supports a maximum data transfer rate of 1250 Mbit/s and operates from a 3.3 V supply. The module is built to meet MSA SFP mechanical and electrical specifications and is certified for ESD, EMI and Laser Eye Safety, providing predictable behavior in standard networking environments. The product is finished in a silver housing and weighs approximately 0.2 kg.

Advantages

This Copper SFP module offers compatibility with SFP-equipped network switches, routers and other devices that accept SFP modules, delivering reliable copper-based connectivity at up to 1250 Mbit/s. Compliance with common safety and interference standards helps ensure stable operation in mixed networking environments. Its small SFP form factor facilitates easy insertion and hot-plug replacement, while the standardized design supports broad vendor interoperability when the host hardware accepts compatible SFP modules.

Suitable for

• 10/100/1000 Mbit Ethernet links over copper using SFP ports
• Upgrading or replacing SFP interfaces in switches and routers that support copper SFP modules
• Short-reach connections in data centers, server rooms and network closets (up to standard copper distances)
• Environments requiring ESD and EMI certified modules for stable operation

Key specifications

• Interface type: SFP (Small Form-factor Pluggable)
• Maximum data transfer rate: 1250 Mbit/s
• Operating voltage: 3.3 V
• Housing colour: Silver
• Weight: 0.2 kg
• Certifications: ESD, EMI, Laser Eye Safety
• Connector type: RJ45 (copper)

How to use

Power down or follow your device's hot-swap procedure if supported, then insert the SFP module into an available SFP port until it seats firmly and the retention latch engages. Connect a suitable RJ45 copper patch cable between the module and the remote device. After insertion and connection, verify link status on the host device and confirm supported speeds and duplex settings in the network equipment configuration. If the host device supports digital diagnostics (DDM/DOM), enable or query diagnostic registers to monitor supply voltage, temperature and optical/electrical parameters where available.

Recommendations

Ensure the host hardware and firmware accept third-party or compatible SFP modules before deployment. Use quality CAT5e or CAT6 copper patch cords for Gigabit operation and keep patching and module contacts free of dust and contaminants. For remote diagnostics and easier troubleshooting, enable any available DDM/DOM monitoring and consult device logs to verify stable operation after installation.