SFP+ lähetin-vastaanotinmoduuli BlueOptics 740-021308-BO 850 nm 300 m

The BlueOptics 740-021308-BO SFP+ transceiver module is a compact optical device for high-speed network links. Operating at a wavelength of 850 nm, it supports multimode fiber transmission up to 300 m and uses an LC duplex fiber connector. The module is supplied in an SFP+ form factor, weighs 20 g and is intended for 10 G-class short-range optical connections where reliable, standards-compliant plug-and-play connectivity is required.

Advantages

The module conforms to common SFP+ MSA mechanical and electrical specifications and is compatible with systems that accept SFP+ 10GBASE-SR optics. Its compact SFP+ form factor and LC duplex connector simplify installation into switches, routers and storage interfaces. Lightweight and finished in grey, the transceiver is designed for straightforward replacement or upgrade of existing short-range fiber links without major infrastructure changes.

Suitable for

• Short-range 10 Gigabit Ethernet links over multimode fiber
• Rack switch uplinks and server-to-switch connections
• Storage area network (SAN) and data center interconnects within 300 m
• Environments requiring hot-pluggable SFP+ transceivers

Key specifications

• Form factor: SFP+
• Wavelength: 850 nm
• Maximum transmission distance: 300 m (multimode fiber)
• Connector type: LC duplex
• Typical use: 10GBASE-SR class short-range optical link
• Weight: 0.02 kg
• Product colour: Grey

How to use

Insert the SFP+ transceiver into a compatible SFP+ slot on your network device until it latches. Connect LC duplex multimode fiber patch cables (observe correct TX/RX orientation) between transceivers or to a patch panel. Ensure the host device supports 10GBASE-SR optics and that any software or firmware policies allow use of third-party transceivers. For best results, use clean connectors and appropriate multimode fiber infrastructure rated for 10 Gbit/s over the intended distance.

Recommendations

Keep fiber connectors clean and capped when not in use, verify optical budgets for the intended multimode fiber type, and confirm host compatibility with SFP+ 10GBASE-SR modules. Regular inspection and cleaning of LC connectors helps maintain signal quality over time.