SFP-lähetin-vastaanotinmoduuli BlueOptics 771-311-BO 1250 Mbit/s

The BlueOptics 771-311-BO SFP transceiver module supports fibre-optic connections with a maximum data transfer rate of 1250 Mbit/s. Housed in a compact SFP form factor with a silver finish, this module is intended for insertion into SFP ports on switches, routers and media converters to enable serial optical links. The design meets common regulatory standards (CE, FCC, RoHS) and is specified with a high mean time between failures (MTBF) of 1,000,000 hours for reliable operation in network environments.

Advantages

This SFP transceiver offers a compact SFP form factor that fits standard hot-pluggable ports, supporting data throughput up to 1250 Mbit/s while keeping a low physical weight. Compliance with CE, FCC and RoHS standards ensures it meets regulatory and environmental requirements. A high MTBF rating indicates long-term operational stability, making the module suitable for continuous network use.

Suitable for

• Hot-pluggable fibre links between switches and routers
• Extending network segments over optical fibre
• Replacing or upgrading existing SFP ports in data center and enterprise equipment
• Use in media converters to bridge copper and fibre connections

Key specifications

• Interface type: SFP hot-pluggable module
• Maximum data transfer rate: 1250 Mbit/s
• Form factor: compact SFP
• Colour: silver
• Weight: approximately 0.02 kg
• MTBF: 1,000,000 hours
• Regulatory compliance: CE, FCC, RoHS

How to use

Power down or follow the host device’s hot-swap procedure, align the SFP module with the SFP slot and insert until it clicks into place. Connect the appropriate fibre patch cable to the transceiver’s optical port, ensuring correct transmitter/receiver orientation and connector type. Configure the host device interface settings (speed and duplex as required) and verify link status through the switch or router management interface. For removal, disengage any latch or release mechanism and pull the module straight out.

Recommendations

Handle the optical connector with dust caps in place until final connection, avoid touching the fibre endface, and keep the module in a static-safe environment during installation. Verify compatibility with the host device’s SFP slot and follow vendor guidelines for supported optical wavelengths and cable types.