SFP+-lähetin-vastaanotinmoduuli BlueOptics AFCT-739SMZ-BO 10000 Mbit/s 1310 nm

The BlueOptics AFCT-739SMZ-BO is an SFP+ fiber optic transceiver module designed for single-mode links with a nominal wavelength of 1310 nm and a maximum data rate of 10000 Mbit/s. The compact, silver-coloured module follows MSA-compatible SFP+ form-factor conventions and is intended for installation in compatible network equipment to provide high-speed optical connectivity. It is RoHS- and CE-compliant and weighs approximately 20 g.

Advantages

The module provides 10G data throughput over single-mode fiber using an LC duplex connector and supports standard SFP+ electrical and mechanical interfaces for wide interoperability. Its compact, lightweight design simplifies installation and replacement in switches, routers and storage systems. Compliance with international safety and environmental standards ensures predictable behaviour in professional networking environments.

Suitable for

• 10 Gigabit Ethernet links over single-mode fiber
• Long-reach optical connections between switches, routers and servers
• Storage area networks and high-performance computing interconnects
• Upgrading or replacing SFP+ ports in compatible network hardware

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbps)
• Wavelength: 1310 nm (single-mode operation)
• Connector: LC duplex (optical)
• Product colour: Silver
• Weight: approx. 0.02 kg
• Compliance: RoHS, CE

How to use

Install the BlueOptics AFCT-739SMZ-BO into an SFP+ slot on compatible network equipment following the host device manufacturer’s hot-swap and handling procedures. Connect an appropriate single-mode LC duplex fiber patch cable to the module’s optical port, ensuring transmit and receive fibers are correctly aligned. Configure the host interface for 10G operation and verify link status through the device management interface. If the host supports digital diagnostics (DDM/DOM), enable and monitor the available optical and electrical parameters where supported by the hardware.

Recommendations

Use this transceiver with certified single-mode patch cords and test links after installation. Verify host compatibility for third-party SFP+ modules and enable digital diagnostics only if supported by the equipment to monitor parameters such as optical power and temperature. Follow ESD precautions during handling and store modules in a dry, temperature-controlled environment.