SFP-lähetin-vastaanotinmoduuli BlueOptics AT-SPLX40-BO 1250 Mbit/s 1310 nm

The BlueOptics AT-SPLX40-BO 1250 Mbit/s 1310 nm is an SFP transceiver module designed for single-fiber and duplex multimode fiber links in networking equipment. It supports up to 1250 Mbit/s data transfer and transmits at a 1310 nm wavelength. The compact SFP form factor allows hot-plug installation into compatible switches, routers and media converters. With a mean time between failures (MTBF) of 1,000,000 hours and compliance with CE, FCC and RoHS standards, this module targets reliable optical connectivity in enterprise and industrial networks.

Advantages

The module offers a standardized SFP interface for easy integration and hot-swapping without powering down equipment. Its 1250 Mbit/s capacity and 1310 nm wavelength provide a balance between distance and compatibility with common single-mode fiber systems. The small silver housing reduces space usage in high-density chassis and the specified MTBF indicates extended operational life. Compliance with international safety and environmental standards ensures interoperability and regulatory conformity.

Suitable for

Key specifications

How to use

Insert the BlueOptics AT-SPLX40-BO into a compatible SFP slot on a switch, router or media converter until it clicks into place. Connect the appropriate fiber optic cable (single-mode compatible at 1310 nm) using the correct connector type for your system. After insertion, verify link status and configure port settings on the host device as needed. To remove the module, power down the port if recommended by the equipment vendor or use the hot-swap latch to extract it safely.

Recommendations

Handle the transceiver by the housing only and avoid touching the optical interfaces; keep dust caps on fiber connectors when not in use. Use single-mode fiber rated for 1310 nm and ensure proper cable attenuation and connector cleanliness to maintain signal quality. Install in compatible equipment that supports SFP modules and observe vendor guidance for hot-swapping and ESD precautions.