SFP+-lähetin-vastaanotinmoduuli BlueOptics ET5402-LR-BO 10000m alumiini

The BlueOptics ET5402-LR-BO SFP+ transceiver module is a single-mode fiber optic solution designed for 10GBASE-LR links up to 10,000 meters. Housed in an aluminium casing and following MSA SFP+ form-factor standards, this module provides optical transmission with an LC duplex connector and supports simultaneous transmit and receive operation over separate fibers. It is intended for integration into network switches, routers, storage systems and other hardware platforms that accept SFP+ modules and support 10GBASE-LR optics.

Advantages

The module offers long-reach 10G transmission over single-mode fiber with an aluminium housing that keeps weight low and supports standard SFP+ installation. It is manufactured to MSA compatibility guidelines and incorporates components designed for robust operation, supporting digital diagnostics (DDM/DOM) when the host device exposes that functionality. The compact SFP+ design enables straightforward hot-plug installation and replacement in compatible network equipment.

Suitable for

Key specifications

How to use

Install the BlueOptics ET5402-LR-BO into the SFP+ port of compatible networking equipment while the device is powered per the host vendor’s instructions or perform hot-plug installation if supported. Connect LC duplex single-mode fiber patch cords to the transceiver and to the remote transceiver or patch panel, ensuring correct Tx/Rx orientation. Verify link status and data rate through the host device’s interface; enable or check DDM/DOM readings in the host management system if diagnostic monitoring is required.

Recommendations

Use high-quality single-mode LC patch cords and adhere to the host equipment’s compatibility list to ensure reliable operation. Confirm that the target hardware supports 10GBASE-LR SFP+ modules and, if needed, enable DDM/DOM support in the system for real-time monitoring of optical parameters.