SFP+ lähetin-vastaanotinmoduuli BlueOptics MTB-LA20-BO 10000 Mbit/s kuitu hopea

The BlueOptics MTB-LA20-BO is an SFP+ fiber optic transceiver module designed for 10 Gbit/s network links. Encased in a metal housing with a silver finish, this compact module supports a maximum data transfer rate of 10000 Mbit/s and operates from a 3.3 V supply. With a lightweight build (approximately 20 g), it is intended for integration into compatible SFP+ ports on switches, routers and optical equipment where a reliable, high-speed fiber connection is required.

Advantages

The module’s SFP+ interface provides a standardized form factor for hot-pluggable installation in data center and enterprise networking equipment. The metal housing offers mechanical durability and electromagnetic shielding while the low operating voltage and small size reduce power and space requirements. Designed for fiber optic links, the transceiver supports stable 10 Gbit/s throughput and predictable physical layer performance for long-term operation.

Suitable for

Key specifications

How to use

Ensure the host device supports SFP+ fiber transceivers and is powered off or in a hot-swap-ready state. Remove any protective caps from the transceiver and the fiber connector, align the module with the SFP+ port, and insert until it engages and latches. Connect the appropriate fiber patch cable to the transceiver’s optical port. Monitor link LEDs or device management interfaces to confirm successful negotiation at up to 10 Gbit/s. To remove, release the latch and pull the module straight out, then replace protective caps as needed.

Recommendations

Use single-mode or multimode fiber and patch cables that match the transceiver’s optical specifications and the host equipment’s requirements. Avoid touching optical endfaces and follow ESD precautions when handling the module. For reliable operation, verify compatibility with the switch or router vendor and ensure firmware or configuration supports SFP+ optics at 10 Gbit/s.