SFP-lähetin-vastaanotinmoduuli BlueOptics SFP-1000BASEX-BO kuitu LC alumiini 20 g

The BlueOptics SFP-1000BASEX-BO is a fiber optic SFP transceiver module designed for 1.25 Gbps optical links. It uses an LC duplex optical connector, has an aluminium housing and weighs approximately 20 g. The module follows SFP form-factor conventions and is intended for insertion into compatible network equipment to enable single-mode or multimode fiber connections depending on the transceiver variant and network design.

Advantages

The module's compact SFP interface provides hot-pluggable transceiver capability for switches, routers and storage systems while the aluminium enclosure ensures mechanical protection and thermal dissipation. At about 0.02 kg the transceiver is lightweight and suitable for dense deployments. The LC connector type is widely used in fiber installations, making the module compatible with common patch cables and fibre panels. The device supports standard 1 G optical networking protocols when used in supported hardware.

Suitable for

Key specifications

How to use

Power off or follow hot-swap guidance for your hardware, then insert the SFP transceiver into a compatible SFP slot until it latches. Connect LC duplex fiber patch cables to the module's LC connector, ensuring transmit and receive fibers are correctly oriented. After installation, verify link status via the host device management interface and confirm the port negotiates the expected 1 G link speed. If present, enable any required digital diagnostic monitoring in the host to read optical parameters.

Recommendations

Use manufacturer-recommended LC patch cables and verify hardware compatibility before deployment. Avoid excessive bending of fiber cables, ensure clean connector endfaces to prevent signal loss, and consult your network equipment documentation for hot-plug procedures and DDM/DOM support to access diagnostic data.