SFP-lähetin-vastaanotinmoduuli BlueOptics SFP-10G-SR-12-BO 10G 850nm

The BlueOptics SFP-10G-SR-12-BO is a 10G multimode fiber SFP transceiver module designed for short-range high-speed data transmission. It supports a maximum data rate of 10000 Mbit/s, operates at an 850 nm wavelength and uses an LC duplex connector. The module is housed in a metal casing, operates from a 3.3 V supply and weighs approximately 3 g, making it compact and suitable for use in switches, routers and other network devices that accept SFP transceivers.

Advantages

This SFP module delivers 10GBASE-SR connectivity over multimode fiber with a small form-factor pluggable interface, providing compatibility with equipment that follows the SFP/SFP+ MSA form factor. The metal housing supports mechanical durability and thermal conduction, while the module’s low weight and standard voltage make it easy to deploy in existing racks and line cards. Support for LC duplex connections enables simultaneous transmit and receive over separate fiber cores.

Suitable for

Key specifications

How to use

Insert the BlueOptics SFP-10G-SR-12-BO into an SFP-capable port following the host device manufacturer’s hot-plugging and electrostatic discharge (ESD) precautions. Connect an LC duplex multimode fiber patch cable with correct polarity to the module and to the corresponding peer transceiver or patch panel. Verify link negotiation and speed settings on the network device; configure any required interface parameters in the switch or router firmware. When removing the module, power down the port if recommended by the equipment vendor and follow safe removal procedures.

Recommendations

Use verified multimode fiber (OM3/OM4 as applicable) and LC duplex patch cords for optimal reach. Ensure the host device supports 10G SFP modules and DDM/DOM features if diagnostic monitoring is required. Follow ESD handling and manufacturer guidance for insertion and removal to maintain long-term reliability.