SFP+-lähetin-vastaanotinmoduuli BlueOptics SFP-10G-SR-AW-BO kupari 10000 Mbit/s

The BlueOptics SFP-10G-SR-AW-BO is an SFP+ transceiver module designed for 10 Gbit/s optical links over multimode fiber. It features an SFP+ interface, operates at an 850 nm wavelength and supports 10,000 Mbit/s data transfer. The module is compact, lightweight (approximately 20 g) and uses an LC duplex connector for simultaneous transmit and receive channels. The BlueOptics unit is built to MSA-compatible mechanical and electrical standards for plug-and-play integration with compatible network equipment.

Advantages

The transceiver provides high-speed 10GBASE-SR connectivity with an 850 nm transmitter and receiver optimized for multimode fiber, enabling low-latency data transfer across short to medium distances. Compliance with SFP+ MSA guidelines ensures broad interoperability with network switches, routers and storage systems that accept SFP+ optical modules. The compact grey module is lightweight and simple to install, and Digital Diagnostic Monitoring (DDM/DOM) support allows remote monitoring of supply voltage, laser bias current, optical transmit/receive power and temperature when supported by the host device.

Suitable for

• 10 Gigabit Ethernet links over multimode fiber in data centers
• High-speed interconnects between switches, routers and servers
• Storage area networks and fibre channel over Ethernet applications
• Short-reach optical links in enterprise network closets and server rooms

Key specifications

• Interface type: SFP+ (pluggable transceiver)
• Maximum data transfer rate: 10,000 Mbit/s (10 Gbit/s)
• Operating wavelength: 850 nm (multimode fiber)
• Connector type: LC duplex
• Typical application: 10GBASE-SR short-reach optical links
• Module colour: grey
• Weight: approx. 0.02 kg

How to use

Install the BlueOptics SFP-10G-SR-AW-BO by inserting the module into an available SFP+ port on a compatible network device until it clicks into place. Connect LC duplex multimode fiber patch cords to the transmit and receive ports following the correct polarity. Ensure the host device supports SFP+ optical modules and, if remote monitoring is required, that the device supports DDM/DOM. After installation, verify link status and speed via the host device management interface and check diagnostic parameters if available.

Recommendations

Use multimode OM3/OM4 fiber for optimal reach and performance at 10 Gbit/s, avoid sharp bends or excessive tensile stress on fiber patch cords, and ensure proper polarity and clean connectors before insertion. Confirm firmware or vendor compatibility if using modules in branded network platforms to access full diagnostic features.