SFP-lähetin-vastaanotinmoduuli BlueOptics SFP-1D-BO 155 Mbit/s 1310 nm

The BlueOptics SFP-1D-BO 155 Mbit/s 1310 nm is a compact SFP fiber-optic transceiver module designed for point-to-point optical links and network equipment that accept SFP form-factor modules. It supports data transfer rates up to 155 Mbit/s over multimode fiber at a nominal wavelength of 1310 nm. Housed in a metal casing and operating from a 3.3 V supply, the module is lightweight and compatible with standard LC duplex connections and MSA-defined SFP interfaces.

Advantages

The module provides a standardized SFP interface and LC duplex fiber connection for bidirectional optical transmission, enabling integration with switches, routers and storage systems that support 100BASE-FX/155 Mbit/s optical links. Its metal housing offers mechanical durability and EMI resilience while the 3.3 V operating voltage and low weight simplify installation and compatibility. The design follows MSA guidelines and is tested for interoperability with equipment that supports equivalent RAD SFP-1D modules, including support for digital diagnostics when the host hardware implements DDM/DOM.

Suitable for

• Fiber links between switches and routers over multimode fiber for distances up to approximately 2 km
• Industrial and enterprise network uplinks where standard SFP modules are required
• Replacement or expansion of SFP ports in storage and networking equipment supporting 100BASE-FX

Key specifications

• Interface type: SFP (MSA-compliant)
• Maximum data transfer rate: 155 Mbit/s
• Wavelength: 1310 nm
• Connector: LC duplex
• Recommended fiber type: multimode fiber
• Operating voltage: 3.3 V
• Housing: metal casing, silver color
• Weight: 0.003 kg

How to use

Install the BlueOptics SFP-1D-BO into an available SFP slot on a compatible switch, router or other network device while the host device is powered down or following the manufacturer's hot-swap guidance. Connect an LC duplex patch cable between this transceiver and the remote transceiver or patch panel, ensuring correct transmit/receive alignment. Configure the host device for the appropriate 100BASE-FX or corresponding protocol and verify link status through the device management interface. If the host supports Digital Diagnostics (DDM/DOM), monitor supply voltage, temperature and optical power values for link health and troubleshooting.

Recommendations

Ensure the host device explicitly supports equivalent RAD SFP-1D/100BASE-FX SFP modules and DDM/DOM if diagnostics are required. Use quality multimode LC duplex fiber patch cords and clean connectors before mating. Observe ESD precautions when handling the transceiver and store it in appropriate protective packaging when not in use.