SFP-lähetin-vastaanotinmoduuli BlueOptics SFP-6-CM-BO 1250 Mbit/s hopea

The BlueOptics SFP-6-CM-BO is a small form-factor pluggable (SFP) fiber optic transceiver module designed for single-mode optical links with a maximum data transfer rate of 1250 Mbit/s. Housed in a silver metal enclosure and weighing approximately 20 g, this module follows industry MSA form-factor conventions and provides a compact optical interface for network equipment that accepts SFP modules. It supports LC duplex connectivity and is intended for high-speed data transmission in networking environments where reliable fiber links are required.

Advantages

The module provides a standardized SFP interface for easy hot-plug installation and interoperability with a wide range of network devices that accept SFP form-factor transceivers. With a maximum data rate of 1250 Mbit/s over single-mode fiber and an LC duplex connector, it supports common Ethernet and optical networking protocols while minimizing electromagnetic interference typical of copper links. Its lightweight silver enclosure simplifies handling and rack-level deployment.

Suitable for

Key specifications

How to use

Insert the BlueOptics SFP-6-CM-BO into an available SFP slot on compatible network equipment while the device is powered on or according to the equipment vendor’s hot-swap instructions. Connect an LC duplex single-mode fiber patch cable to the module’s LC connector, observing correct transmit/receive orientations. Verify link status in the host device management interface and ensure the connected port is configured for the expected speed and protocol. If the host supports digital diagnostic monitoring (DDM/DOM), enable or query the diagnostics according to the hardware documentation to view supply voltage, laser parameters and temperature where supported.

Recommendations

Use high-quality single-mode LC duplex patch cords and clean fiber connectors before mating to ensure optimal signal integrity. Confirm compatibility with the host device’s supported SFP transceiver types and firmware requirements to avoid link issues. Operate the module within the equipment manufacturer’s ambient temperature and humidity ranges and follow electrostatic discharge precautions when handling the transceiver.