SFP-lähetin-vastaanotinmoduuli BlueOptics SFP-BXU35-20KM-MT-BO 1250 Mbit/s

The BlueOptics SFP-BXU35-20KM-MT-BO is a single‑fiber SFP transceiver module designed for point‑to‑point fiber links with a maximum data transfer rate of 1250 Mbit/s. Housed in a metal casing with a compact form factor and a weight of 20 g, the module provides a combination of physical robustness and compatibility with standard SFP slots. An MTBF of 1,000,000 hours indicates long operational life for installed network equipment.

Advantages

The metal housing offers thermal stability and mechanical protection while the SFP form factor ensures broad compatibility with switches and routers that support SFP modules. With a maximum data rate of 1250 Mbit/s and support for long‑distance fiber connections, this transceiver is suitable for stable uplinks and interconnects. Its light weight and compact dimensions facilitate installation in dense networking environments.

Suitable for

Key specifications

How to use

Install the SFP transceiver into an empty SFP port on your switch or router until it clicks into place, then connect the appropriate single‑fiber cable following the device manufacturer’s polarity and connector type guidance. Verify link status via the host device’s management interface and perform any required configuration such as speed and duplex settings if applicable. Handle the module by its housing and protect the optical interfaces with dust caps when not connected.

Recommendations

Store and operate the transceiver within the environmental ranges specified by your network equipment vendor. Use clean fiber connectors and inspect end faces before mating to prevent signal loss. Replace protective dust caps only when ready to connect and avoid touching the optical surfaces to maintain signal quality and module longevity.