SFP-lähetin-vastaanotinmoduuli BlueOptics SFP28-25G-ER-IT-BO 25000 Mbit/s

The BlueOptics SFP28-25G-ER-IT-BO is a fiber optic SFP transceiver module designed for high-speed data transmission at up to 25 Gbit/s. With an SFP28 interface and a compact form factor, this module integrates into compatible switches, routers and optical equipment to extend link distances and support reliable long-reach connections. The module's lightweight construction (approx. 0.04 kg) and standard SFP28 housing make it suitable for dense, space-constrained network racks.

Advantages

This SFP28 transceiver provides a clear upgrade path for 25 Gbit/s Ethernet and supports established SFP28 sockets without changing host hardware. The module's fiber optic design reduces electromagnetic interference and delivers consistent throughput over longer distances compared with copper links. Its compact size and standardized interface simplify installation and replacement in managed network environments.

Suitable for

• 25 Gbit/s Ethernet uplinks in data center switches and aggregation equipment
• Long-reach fiber connections between racks and buildings
• Optical links in carrier and enterprise network infrastructure
• Upgrading existing SFP28-capable ports for higher bandwidth

Key specifications

• Interface type: SFP28
• Maximum data transfer rate: 25000 Mbit/s (25 Gbit/s)
• Form factor: SFP28 compatible transceiver
• Weight: 0.04 kg
• Optical medium: single-mode or multimode fiber (dependant on specific link planning)

How to use

Install the BlueOptics SFP28-25G-ER-IT-BO into an empty SFP28 port on a compatible switch or router until it clicks into place, then secure the module if the host device requires a latch or screw. Connect the appropriate fiber optic cable to the transceiver's connector, observing correct polarity and connector type. After physical installation, verify link status and configure the port on the network device for the desired speed and duplex settings. Monitor link integrity and optical power via the host device management interface if supported.

Recommendations

Confirm compatibility with the host device's SFP28 port and check the required optical fiber type and connector before installation. Use proper ESD precautions during handling, avoid bending fiber cables beyond recommended radii, and verify link parameters after deployment to ensure optimal performance.