SFP+-lähetin-vastaanotinmoduuli BlueOptics TN-SFP-10G-SR-BO 10000 Mbit/s

The BlueOptics TN-SFP-10G-SR-BO is an SFP+ fiber optic transceiver module designed for optical networks requiring 10G data rates. It supports a maximum data transfer rate of 10000 Mbit/s, uses an SFP+ interface and is housed in a durable silver metal casing that weighs approximately 20 g. The module implements short-range multi-mode fiber transmission with an LC duplex optical connector and is built to conform with MSA mechanical and electrical standards, providing plug-and-play compatibility with equipment that supports 10GBASE-SR SFP+ modules.

Advantages

The transceiver offers compatibility with standard SFP+ ports and a compact metal form factor that simplifies installation and thermal performance. With a specified MTBF of 1,000,000 hours and a lightweight design, the module is intended to deliver long operational life and minimal maintenance requirements. Its silver metal housing and standard LC duplex connector make it suitable for integration into a wide range of switches, routers and storage interfaces that accept SFP+ optics.

Suitable for

Key specifications

How to use

Power down or follow hot-swap procedures recommended by your equipment vendor before inserting or removing the SFP+ transceiver. Align the LC duplex connector and gently insert the module into the SFP+ slot until it latches. Connect multi-mode fiber patch cords with matching LC duplex connectors and verify link status through your switch or router management interface. If the host device supports digital diagnostics, enable monitoring to view parameters such as optical power and temperature where supported.

Recommendations

Use short-wave 850 nm multi-mode fiber and high-quality LC duplex patch cords for optimal short-range performance. Ensure the host equipment explicitly supports 10GBASE-SR SFP+ modules and, if available, enable digital diagnostics monitoring for proactive link management. Follow manufacturer guidelines for hot-swap handling and ESD precautions during installation.