SFP28-lähetin-vastaanotinmoduuli BlueOptics RDH901082/1-BO 25000 Mbit/s

The BlueOptics RDH901082/1-BO SFP28 transceiver module is a compact optical module designed for high-speed network environments. It supports a maximum data transfer rate of 25000 Mbit/s and is built to industry SFP28 form-factor standards with an LC duplex connector for multimode fiber connections. The module has a silver housing, a lightweight construction of approximately 20 g, and a high reliability rating with an MTBF of 1,000,000 hours, making it suitable for integration into modern networking equipment that accepts SFP28 transceivers.

Advantages

The module delivers 25 Gbit/s-class performance in a small SFP28 package, enabling denser port configurations and straightforward upgrades from lower-speed transceivers. Its compliance with common SFP28 mechanical and electrical interfaces ensures compatibility with equipment that supports SFP28 optics. The lightweight silver housing and standardized LC duplex connector simplify installation and cabling in rack and data center environments.

Suitable for

Key specifications

How to use

Prior to installation, verify that the host device supports SFP28 modules and the supported transmission protocols. Insert the transceiver into an available SFP28 slot until it latches, then connect LC duplex multimode fiber patch cords to the module ports following correct polarity. Configure the host interface according to the network settings and confirm link status through the device management interface. For removal, power down the interface if required by the host, depress the latch and gently pull the module from the port.

Recommendations

Use multimode fiber patch cords rated for 850 nm and keep connectors clean to maintain signal quality. Confirm compatibility with your specific hardware platform and firmware version before deployment; where possible, test a sample module in a non-production environment to validate link stability and performance.