SSD-kiintolevy Lenovo 512 GB M.2 PCIe 2280 Micron 2300 MTFDHBA512TDV-1AZ1AABLA

The Lenovo Micron 2300 512GB M.2 PCIe 2280 SSD is a compact solid-state drive designed to increase system responsiveness in laptops and desktops. Using a PCIe 3.0 interface and the M.2 2280 form factor, this SSD delivers faster boot times, quicker application launches and improved file transfer performance compared with traditional hard drives. The drive incorporates modern NAND flash technology to provide a balance of sustained performance and endurance while keeping a small physical footprint that fits most M.2 slots.

Advantages

This SSD provides high sequential and random read/write performance typical for PCIe 3.0 NVMe devices, reduced latency compared to SATA storage, and lower power consumption during active and idle states. Its M.2 2280 form factor allows direct installation on compatible motherboards and notebooks without the need for extra cables. The drive's NAND architecture and controller firmware are optimized for reliability and consistent throughput under everyday workloads.

Suitable for (tasks / use cases)

• Operating system drive to accelerate boot and system responsiveness
• Application storage for faster loading of productivity and creative software
• Game installation to reduce level load times and texture streaming delays
• General file storage and transfer for documents, photos and media

Key specifications

• Form factor: M.2 2280
• Interface: PCIe 3.0 (NVMe protocol)
• Capacity: 512 GB
• NAND type: Micron advanced NAND flash
• Power characteristics: low-power operation suitable for mobile devices
• Physical dimensions: single-sided M.2 2280 module (standard length and width)

How to use

Install the M.2 SSD into an available M.2 2280 slot on a compatible motherboard or laptop following the device manufacturer’s instructions. Secure the module with the mounting screw and, if required, configure the system BIOS/UEFI to recognize the NVMe drive. Initialize and partition the drive in the operating system storage management utility before installing an OS or transferring data. For cloning an existing system, use reliable disk cloning software that supports NVMe targets and follow the software vendor’s guidance.

Recommendations

For optimal performance, enable NVMe mode in BIOS/UEFI and use the latest storage drivers provided by the system or motherboard vendor. Keep firmware updated when updates are available from the manufacturer. Use standard backup procedures to protect important data and avoid filling the drive to full capacity to maintain sustained write performance.