T-liitin ShiverPeaks 83200 2 liittimellä ja 1 tulpalla

The T-Connector ShiverPeaks 83200 with 2 couplings and 1 plug is a three-way connector designed for joining or branching lines in plumbing and electrical applications. It delivers a compact, sealed branch where two lines are connected and a third outlet is closed with a plug. The unit is intended for installations that require a capped or temporarily unused third port while maintaining reliable coupling connections on the remaining two outlets.

Advantages

This T-connector offers a space-saving three-way junction that simplifies line routing and branching without the need for additional adapters. Supplied with two couplings and one plug, it eliminates the need to source separate end fittings and enables a sealed third outlet. The straightforward coupling interfaces reduce installation time and support a tidy, compact assembly suitable for confined spaces.

Suitable for

• Branching liquid or gas lines where one outlet must be capped
• Electrical conduits requiring a sealed third port
• Tight installation spaces needing compact three-way connections
• Temporary or future expansion points where a plug is required

Key specifications

• Three-way T configuration with two active couplings and one plug
• Compact form factor for confined installation areas
• Designed for sealed or capped third outlet
• Compatible with straightforward coupling connections for rapid assembly

How to use

Position the T-connector at the desired junction point and connect the two active lines into the coupling ports, ensuring correct alignment and a secure fit. Install the plug into the third port to seal the branch; confirm that the plug is seated fully to prevent leaks or ingress. Follow standard installation procedures for the specific system (plumbing or electrical), including appropriate sealing materials, torque values, and safety precautions relevant to the media and local codes.

Recommendations

Check compatibility with the pipe or conduit material and the operating pressure or voltage before installation. Use recommended sealing compounds or gaskets where applicable, and perform a leak or continuity test after installation. Replace the plug with a coupling only when the branch will be activated, and ensure all connections are tightened to manufacturer or system specifications.