Vaihtopyyhintyyny Xiaomi S40 Pro H50 Pro -imurirobotille (malli BHR08VBGL) — pyyhintätarvike

Replacement mop pad designed for wet mopping with compatible Xiaomi robot vacuum models S40 Pro and H50 Pro. This mop accessory restores the robot's wiping performance by providing an even, absorbent surface for water distribution and mechanical wiping to remove dirt and light stains from hard floors. The pad is simple to attach and remove from the robot’s mop holder and is washable for repeated use, helping to maintain consistent cleaning results over time.

Advantages

The replacement mop pad offers uniform water retention and release to support consistent wet cleaning across hard floor surfaces. Its textile surface is engineered to pick up fine dust and light soiling while allowing the robot’s mop system to glide smoothly. Being washable increases cost-effectiveness and reduces waste compared with single-use pads. The pad’s shape and attachment points match the robot’s mop module to ensure secure fit and reliable operation during cleaning cycles.

Suitable for

• Routine wet mopping of sealed hard floors such as tile, vinyl, and finished hardwood
• Removing light stains, dried spills, and smudges between deeper cleaning sessions
• Maintaining floor appearance in homes with pets or moderate foot traffic
• Replacing worn or heavily soiled mop pads to restore wiping efficiency

Key specifications

• Compatible form factor for robot mop holder and mounting points
• Absorbent textile surface optimized for even water distribution
• Machine-washable fabric for multiple reuse cycles
• Low-profile design to maintain robot navigation and floor clearance
• Durable stitching and secure attachment zones for repeated installation

How to use

Attach the replacement mop pad to the robot’s mop holder by aligning the pad with the attachment points and pressing until it clicks into place. Dampen the pad according to the robot manufacturer’s wet-mop instructions or use the robot’s water tank settings to control moisture level; do not oversaturate. Run the robot on an appropriate wet-mop cleaning mode to remove dirt and stains. After use, remove the pad, rinse under running water to remove debris, and launder according to care guidance. Allow the pad to fully air dry before reattaching to avoid odors or mildew.

Recommendations

To prolong pad life and preserve cleaning performance, rinse the pad immediately after each use, avoid high-temperature washing cycles, and allow complete air drying. Replace the pad when fibers show significant wear or when washing no longer restores absorbency.