Verkko-lähetin-vastaanotinmoduuli BlueOptics SP-GB-EX-CDFC-BO 125000 Mbit/s SFP 1310 nm

The BlueOptics SP-GB-EX-CDFC-BO is an SFP network transceiver module designed for optical data transmission at a maximum rate of 125000 Mbit/s. It uses a 1310 nm transmitter/receiver pair and an LC duplex connector to send and receive optical signals over single-mode and selected multimode fiber types. The module is compact and lightweight (0.02 kg) and follows MSA-compatible SFP form-factor specifications for plug-and-play installation in compatible switches, routers and other networking devices.

Advantages

The module provides high-speed optical connectivity with a 1310 nm wavelength suitable for long-distance links when used with single-mode fiber. MSA compliance ensures interoperability with a wide range of network equipment that supports SFP transceivers. The compact SFP form factor and LC duplex interface simplify integration into patch panels and chassis-based systems. Its low weight and standardized interface make it convenient for deployment in dense networking environments.

Suitable for

• High-speed Ethernet links and uplinks in data centers and enterprise networks
• Interconnecting switches and routers over fiber optic cabling
• Long-reach fiber links using single-mode fiber (9/125 µm)
• Replacement or upgrade of existing SFP optical modules in compatible hardware

Key specifications

• Interface type: SFP (MSA-compliant form factor)
• Wavelength: 1310 nm (transmit and receive)
• Maximum data transfer rate: 125000 Mbit/s (1.25 Gbit/s class performance)
• Connector: LC duplex optical connector
• Supported fiber types: 9/125 µm (single-mode) and selected multimode fibers such as 50/125 µm and 62.5/125 µm when applicable
• Weight: 0.02 kg

How to use

Install the BlueOptics SFP module into the SFP port of a compatible network device until it clicks into place. Connect an LC duplex fiber patch cable to the module, observing transmit/receive orientation and using appropriate single-mode or multimode fiber for the intended link distance. Configure the host device network settings as required and verify link status through the device management interface. If the host supports digital diagnostics (DDM/DOM), enable or read diagnostic data to monitor parameters such as optical power and temperature.

Recommendations

Use single-mode 9/125 µm fiber for optimal long-distance performance with the 1310 nm wavelength. When using multimode fiber (50/125 or 62.5/125 µm), verify compatibility and link budget for shorter distances. Keep fiber connectors clean and use dust caps when ports are unused. Ensure the host device firmware or drivers support third-party SFP modules and, if available, make use of DDM/DOM for ongoing monitoring of the optical link.