Verkkokaapeli Draka Comteq TM31 Patch Cat6 3 m punainen

The Draka Comteq TM31 Patch Cat6 3m Red is a 3-meter Category 6a patch cable with RJ-45 connectors on both ends, designed for reliable high-speed data transmission in wired networks. Its Cat6a specification supports improved signal integrity and bandwidth compared with earlier categories, making it suitable for gigabit and multi-gigabit Ethernet links in structured cabling systems. The red jacket provides clear visual identification in patch panels and cable runs while maintaining a flexible form factor for typical office, data center, or home networking environments.

Advantages

This Cat6a cable delivers consistent performance for demanding network applications by supporting higher frequencies and reduced crosstalk. The factory-terminated RJ-45 plugs ensure secure and low-loss connections, and the 3 m length offers a balance between reach and cable management in patching scenarios. The colored outer jacket aids quick identification of network segments and reduces troubleshooting time in complex installations.

Key specifications

• Category: Cat6a (meets enhanced Cat6 performance)
• Length: 3 meters
• Connectors: RJ-45 plugs on both ends
• Color: red outer jacket for visual identification
• Application: suitable for Gigabit and multi-Gigabit Ethernet links
• Construction: stranded conductor for patching flexibility

How to use

Route the cable between network devices such as switches, routers, patch panels or network outlets, taking care to avoid tight bends and sharp edges. Insert the RJ-45 plugs fully into the device ports until they latch; confirm link status on the connected devices. For neat cable management, use appropriate cable ties or organizers and avoid running data cables in parallel with high-voltage power lines to minimize interference.

Recommendations

For optimal performance, use this Cat6a patch cable for short interconnects within racks, between patch panels and switches, or for direct device connections where a 3 m length is appropriate. Maintain bend radius limits specified by industry practice and replace cables that show visible damage or degraded connectivity.