Verkkokaapeli EFB Elektronik K8100SW.7,5 RJ-45 Cat6 7,5 m musta

The EFB Elektronik K8100SW.7,5 RJ-45 Cat6 7.5 m Black is a network patch cable designed for reliable wired connections in home and office environments. Built to the Cat6 specification with U/UTP shielding, the cable supports high-speed data transfer and stable signal integrity over a 7.5 meter length. Gold-plated RJ-45 connectors provide improved contact conductivity and resistance to corrosion while the black jacket offers a neutral appearance that fits into most installations.

Advantages

The Cat6 construction with U/UTP shielding reduces crosstalk and external electromagnetic interference, helping to maintain consistent throughput. With support for data rates up to 5000 Mbit/s, the cable is suitable for demanding network tasks where bandwidth and low latency are important. Gold-plated RJ-45 plugs deliver reliable connectivity and longer contact life compared to non-plated contacts. The 7.5 m length balances reach and cable management for typical desktop-to-switch or rack-to-device runs.

Suitable for

• Wired connections between computers, switches and routers
• Office network cabling and patch panels
• Home networks for streaming, gaming and large file transfers
• Temporary setups, meetings and conference room connectivity

Key specifications

• Type: Cat6 U/UTP network cable
• Length: 7.5 m
• Connectors: RJ-45 to RJ-45, gold-plated contacts
• Rated data speed: up to 5000 Mbit/s
• Colour: Black

How to use

Insert each RJ-45 connector into the corresponding Ethernet port on your devices until the latch clicks into place. Route the 7.5 m cable to avoid sharp bends and avoid placing it parallel and close to power cables to reduce possible interference. For best performance, ensure both connected devices support the intended network speed and verify link activity via device indicators or management interfaces. To disconnect, depress the clip on the RJ-45 plug and gently pull the connector out of the port.

Recommendations

Use the cable in indoor network installations and avoid exposure to direct sunlight, moisture or mechanical strain. For permanent installations in high-interference environments, consider shielded or higher-category cabling. Regularly inspect connectors for dirt or damage and replace the cable if contacts become loose or corroded.