Verkkokaapeli EFB Elektronik K8560SW.10 RJ45 Cat6a 10 m musta

The EFB Elektronik K8560SW.10 RJ45 Cat6a 10m networking cable is built for stable, high-speed wired connections. Complying with Cat6a specifications, the cable supports 10 Gigabit Ethernet performance over a 10 m length and features standardized RJ-45 connectors on both ends. Its black outer jacket provides a neutral appearance suitable for home, office and data center environments while offering mechanical protection for the internal conductors.

Advantages

This Cat6a cable delivers up to 10 Gbps data throughput where supported by connected devices and network equipment. Its 10 m length balances reach and signal integrity for typical room-to-room or rack-to-workstation runs. The use of RJ-45 connectors ensures compatibility with a wide range of network ports. The outer sheath in black increases resistance to everyday wear and helps conceal the cable in installations where aesthetics matter.

Suitable for

• Wired connections between PCs, switches and routers
• High-bandwidth applications such as gaming, 4K streaming and large file transfers
• Office and home network installations requiring reliable Ethernet links
• Temporary or permanent cabling runs in small server rooms or media setups

Key specifications

• Cable category: Cat6a (augmented Category 6)
• Maximum supported speed: up to 10 Gbps (subject to connected hardware and environment)
• Length: 10 m
• Connectors: RJ-45 to RJ-45
• Colour: Black

How to use

Insert each RJ-45 connector into the corresponding Ethernet port of your network devices until the connector latch clicks into place. Use the 10 m cable to link switches, routers, PCs or other Ethernet-enabled devices. For best performance, avoid tight bends, kinks and close parallel runs alongside high-power electrical cables. When disconnecting, press the connector latch and pull the plug straight out to avoid damaging the connector or port.

Recommendations

To maintain optimal transmission quality, route the cable away from sources of strong electromagnetic interference and secure it to prevent strain at connector ends. Verify compatibility of equipment to support Cat6a and 10 Gbps speeds; where devices support lower speeds the cable will operate at the highest mutually supported rate.