Verkkokaapeli Garbot B-02-50700 harmaa 7 m Cat6 U/UTP

The Garbot B-02-50700 is a 7 m Cat6 U/UTP patch cable with RJ-45 connectors on both ends, designed for networking connections between devices. The cable uses unshielded twisted pair construction with four stranded copper pairs and gold-plated contacts to ensure reliable conductivity. Molded kink protection and a flexible jacket support narrow bending and everyday handling in home and office environments.

Advantages

This Cat6 U/UTP cable provides high-speed data transmission compatible with standard Ethernet networks. Gold-plated RJ-45 plugs reduce contact resistance and corrosion, while the moulded kink protection increases connector durability. The 1:1 contact wiring follows the EIA/TIA 568 standard for straightforward installation and predictable performance.

Suitable for

• Connecting PCs, switches and routers in home or office networks
• Patch panel to network device connections
• Temporary or permanent Ethernet links where a 7 m length is appropriate

Key specifications

• Cable type: Cat6 U/UTP (unshielded)
• Length: 7 m
• Connectors: RJ-45 to RJ-45, gold-plated contacts
• Contact wiring: 1:1 (EIA/TIA 568)
• Construction: 4-pair stranded copper
• Colour: Grey
• Manufacturer part number (MPN): B-02-50700
• EAN: 7630049616479

How to use

Insert each RJ-45 connector into the corresponding network port until the latch clicks. Route the cable to avoid sharp edges and heavy compression; use cable management to keep runs neat. For best signal performance, avoid running the cable parallel to high-voltage power lines and minimize tight bends that exceed the cable's bend radius.

Recommendations

For reliable performance, use the Garbot B-02-50700 for short to medium-length Ethernet links up to 7 m in typical home and office setups. Replace the cable if the outer jacket or connector shows visible damage or if intermittent connectivity occurs.