Verkkokaapeli helos Ultra ohut RJ-45-liitin - RJ-45-liitin 5 m S/FTP CAT6a

Shielded patch cable helos Ultra Slim RJ-45 M to RJ-45 M, 5 m length, designed for high-speed Ethernet connections. The cable uses S/FTP (shielded foil around each pair plus overall braid) construction and meets CAT6a specification, enabling reliable data transmission up to 10 Gbps and improved protection against electromagnetic interference. With slim, flexible jacket and standard RJ-45 male connectors on both ends, this cable is suitable for tight spaces and neat cable routing in home and office networks.

Advantages

The S/FTP shielding provides individual pair protection plus an overall braid, reducing crosstalk and external noise for stable signals at higher data rates. CAT6a performance supports 10 Gbps network segments and higher bandwidth applications while maintaining consistent latency. The ultra-slim jacket increases flexibility and simplifies cable management in racks, patch panels and behind furniture. Standard RJ-45 male connectors ensure broad compatibility with switches, routers, network cards and patch panels.

Suitable for

• Connecting switches, patch panels and routers in structured cabling installations
• High-speed Ethernet workstations and servers requiring up to 10 Gbps
• Home and office LANs where slim, flexible cabling is needed for tight routing
• Environments with potential electromagnetic interference where shielding is beneficial

Key specifications

• Cable type: S/FTP (shielded foil around each pair + overall braid)
• Category: CAT6a
• Length: 5 m
• Connectors: RJ-45 male to RJ-45 male
• Data rate support: up to 10 Gbps
• Impedance: 100 Ω (typical for Ethernet cabling)
• Conductor: multi-pair twisted copper
• Outer diameter: ultra-slim jacket for improved flexibility and space-saving routing

How to use

Plug the RJ-45 male connectors into the corresponding Ethernet ports of your devices, such as switches, routers or network interfaces. Ensure connectors are fully seated until the latch clicks to guarantee proper contact. Route the cable avoiding sharp bends and high-tension points; the slim jacket allows routing through narrow openings and behind equipment. For installations in racks or patch panels, label both ends as needed for identification. Periodically inspect connectors and cable jacket for damage and replace the cable if shielding or conductors are compromised.

Recommendations

For optimal performance, avoid running the cable parallel and close to high-voltage power lines or large electrical equipment. When connecting 10 Gbps equipment, keep cable runs within recommended lengths for CAT6a and use properly terminated patch panels and certified network hardware to preserve signal integrity.