Verkkokaapeli LOGON Cat6 UTP 7 m, RJ-45–RJ-45, vihreä

LOGON Cat6 UTP networking cable, 7 m length, with RJ-45 connectors on both ends designed for gigabit Ethernet and fast data transmission. The cable uses 4 pairs of 26 AWG stranded conductors in an unshielded twisted pair (UTP) configuration with 100 Ω characteristic impedance and is rated to 250 MHz. The green outer jacket makes the cable easy to identify in patch panels and cable runs. The cable includes boots with kink protection and strain relief to reduce connector stress and improve durability during repeated plug/unplug cycles.

Advantages

This Cat6 cable supports reliable gigabit Ethernet connections and is suitable for structured cabling in home and office environments. The 26 AWG stranded pairs balance flexibility with signal integrity for patching between network devices, while the 250 MHz bandwidth and Category 6 certification ensure compatibility with modern networking equipment. The integrated boots with strain relief protect the RJ-45 connectors and extend service life, and the colored jacket simplifies cable management.

Suitable for

• Connecting routers, switches and network hubs to PCs and servers
• Patching between wall outlets and patch panels in home or small office networks
• Temporary or permanent network connections in closets and telecom cabinets
• Wiring networked printers, IP cameras and other Ethernet devices over short to medium distances

Key specifications

• Length: 7 m
• Cable type: Cat6, UTP (unshielded twisted pair)
• Conductor: 4 × 2, 26 AWG stranded (26/7)
• Characteristic impedance: 100 Ω
• Bandwidth: up to 250 MHz
• Connectors: RJ-45 male to RJ-45 male
• Connector features: boot with kink protection and strain relief
• Wiring: 1:1 straight-through connection
• Jacket color: green

How to use

Plug one RJ-45 connector into the network port of your router, switch or network device and plug the other RJ-45 connector into the corresponding port on a PC, patch panel or wall outlet. Ensure connectors are fully inserted until the latch clicks to secure the connection. Route the cable to avoid sharp bends and excessive tension; the integrated boot and strain relief reduce stress at the connector but do not replace careful cable management. For best performance, avoid running the cable parallel to power lines for long distances.

Recommendations

For optimal signal integrity, use this Cat6 UTP cable for patching and short- to medium-length horizontal runs up to the recommended 7 m. When installing in structured cabling, terminate and test connections with appropriate tools and certification testers if required by your network policy. Replace the cable if the jacket or connectors show visible damage.