Virtalähde Evoko 24V 2A malli 909.1936.900 Evoko Liso Roomille

This power supply provides a stable 24 V DC output at 2 A and is intended as a direct replacement or spare unit for the Evoko Liso Room device. It supplies consistent voltage to the room display, sensors and internal electronics so the Evoko Liso Room can operate reliably in meeting room and office environments. The unit is compact and designed for easy desk or wall-mounted installation using the compatible connector type.

Advantages

The adapter delivers a regulated 24 V output with up to 2 A current capacity to ensure consistent performance of the Evoko Liso Room under normal operating conditions. Its compact form factor and standard connector make installation straightforward, while built-in protections maintain stable voltage to connected electronics. As a spare or replacement part, it restores device power without requiring changes to the original installation.

Suitable for

• Powering Evoko Liso Room meeting room displays
• Replacing a faulty or lost original power adapter
• Maintaining consistent operation of room sensors and indicators
• Desk- or wall-mounted installations with compatible connector

Key specifications

• Output voltage: 24 V DC
• Output current: 2 A
• Output type: regulated DC suitable for low-voltage electronics
• Typical use: indoor, climate-controlled environments
• Physical form factor: compact external adapter for desk or wall mounting

How to use

Disconnect power from the existing adapter before replacing it. Connect the compatible plug to the Evoko Liso Room power input and plug the adapter into a grounded AC outlet that matches the adapter’s input rating. After connection, verify the device powers on and functions normally. If the device does not power on, check the outlet and connector for proper contact and inspect cables for damage.

Recommendations

Use the adapter indoors in dry, temperature-controlled environments. Avoid exposing the adapter to moisture, direct sunlight or excessive heat. If permanent mounting is required, ensure the adapter and cable routing do not strain the connector. Replace the adapter if it shows signs of damage or inconsistent output.