XFP-lähetin-vastaanotin-moduuli BlueOptics 407-10949-BO 10000 Mbit/s

The BlueOptics 407-10949-BO is an XFP fiber optic transceiver module designed for high-speed 10 Gbps network links. With an XFP form factor, a compact silver housing and a lightweight build (approx. 20 g), this module supports a maximum data transfer rate of 10000 Mbit/s and is intended for use in compatible network equipment. The product meets CE, FCC and RoHS regulatory requirements and is specified with a mean time between failures (MTBF) of 1,000,000 hours.

Advantages

This BlueOptics XFP transceiver provides a standardized interface for 10 Gbit/s optical connections, combining a small form factor with broad compatibility in systems that accept XFP modules. Its low weight and metal housing contribute to straightforward handling and robust installation in dense network environments. Compliance with common regulatory standards ensures conformity for professional and enterprise deployments.

Suitable for

• 10 Gbit/s fiber uplinks in core, aggregation or distribution switches
• High-speed links between routers, switches and servers
• Data centre interconnects and fiber backbone segments
• Replacement or upgrade of existing XFP ports

Key specifications

• Form factor: XFP
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Product colour: Silver
• Weight: 0.02 kg (approx. 20 g)
• Mean time between failures (MTBF): 1,000,000 hours
• Regulatory compliance: CE, FCC, RoHS

How to use

Install the BlueOptics 407-10949-BO into any compatible XFP slot on network switches, routers or media converters following the host device manufacturer's instructions. Ensure the device is powered down or hot-swap capable per the equipment manual, insert the transceiver gently until it seats, and connect the appropriate fiber cable to the optical connector. Verify link status and configure the host interface at the required data rate and duplex settings as needed.

Recommendations

Handle the transceiver by its housing to avoid contaminating optical interfaces. Use dust caps when connectors are not in use, clean fiber connectors before mating, and verify compatibility with the host device's supported XFP modules and optical parameters prior to deployment.