XFP-lähetin-vastaanotinmoduuli BlueOptics RDH90165/1-BO 10000 Mbit/s 1310 nm

The BlueOptics RDH90165/1-BO XFP transceiver module is designed for single-mode fiber optic links that require 10 Gbit/s throughput at a wavelength of 1310 nm. Housed in a metal casing and weighing approximately 4 g, this XFP module implements an XFP interface and operates from a 3.3 V supply. It features an LC duplex optical connector and is intended for use in compatible networking equipment that supports XFP 10GBASE-LR modules.

Advantages

This XFP module offers 10 Gbit/s maximum data transfer rate over single-mode fiber at 1310 nm while maintaining a compact and lightweight metal housing. The module supports standard XFP electrical and optical interfaces, enabling straightforward replacement or upgrade in systems that accept XFP form-factor transceivers. Its small size and low power supply voltage simplify installation and integration into data center and enterprise network hardware.

Suitable for

Key specifications

How to use

Install the BlueOptics RDH90165/1-BO XFP by inserting it into an XFP-capable port on compatible network equipment until it seats securely, then connect LC duplex single-mode fiber patch cords to the transmit and receive ports. Power the host device according to its manufacturer instructions; the module draws its operating power from the host 3.3 V supply. After physical installation, verify link status and negotiate the connection at 10 Gbit/s in the host device management interface or via network monitoring tools.

Recommendations

Use single-mode LC duplex patch cords and appropriate fiber management (patch panels or protected routing) to achieve the best optical performance. Confirm that the host equipment supports XFP transceivers and the 10GBASE-LR optical specification before installation. If digital diagnostic monitoring (DDM/DOM) is required, ensure that the host platform exposes and reads the module diagnostics via its management interface.