Yongnuo YN560-TX II langaton salaman ohjain Canonille

The YN560-TX II puts full manual control of Yongnuo's 2.4 GHz flash system at your fingertips, turning a single hot-shoe slot into a command centre for up to six groups. Unlike a basic trigger, it lets you adjust power, zoom, and mode for each group remotely, so you can shape light without walking back to each flash.

Highlights

• Controls Yongnuo RF-602, RF-603, RF-603 II, RF-605, YN560-III, YN560-IV, YN660, YN968N, and YN860Li flashes
• 16 channels and 6 groups (A–F) for multi-flash setups
• Manual and stroboscopic (multi) modes with 1/3-stop power adjustment from 1/1 to 1/128
• Remote zoom control for compatible flashes (24–105 mm)
• Large backlit LCD for clear visibility in dim conditions
• Runs on 2 AA batteries for up to 1200 flashes

In daily use

Mount the YN560-TX II on your Canon camera's hot shoe, set the channel to match your receivers, and you're ready to trigger and adjust flashes from up to 100 metres away. The backlit screen shows all groups at a glance, and the intuitive buttons let you change settings quickly during a shoot. A PC sync port and USB port round out the connections for studio integration and firmware updates.

Full specifications

• Compatibility: Canon EOS cameras
• Wireless frequency: 2.4 GHz
• Wireless range: up to 100 m
• Channels: 16
• Groups: 6 (A, B, C, D, E, F)
• Flash modes: Manual, Multi (stroboscopic)
• Power control: 1/1 to 1/128 in 1/3-stop increments
• Zoom control: 24–105 mm (remote for compatible flashes)
• Display: Large LCD with backlight
• Power source: 2 x AA batteries
• Battery life: approx. 1200 flashes (alkaline)
• Interface: Camera hot shoe, PC sync port (input/output), USB port
• Firmware upgrade: Yes, via USB
• Maximum sync speed: 1/250 s (camera dependent)
• Operating temperature: 0°C to 40°C
• Mounting: Hot shoe mount

Final note

A compact but powerful controller that brings studio-style control to location shoots, especially for photographers already invested in Yongnuo's radio-equipped flashes.