12V 7A Blue Smart IP67 laturi Victron Energy BPC120713006 lyijy-happo- ja litiumakuille

Blue Smart IP67 Charger Victron Energy BPC120713006 is a 12V, 7A battery charger engineered for reliable charging of lead‑acid and compatible lithium batteries. The unit combines a compact, waterproof housing with stable current delivery to support daily use, maintenance charging and long‑term storage. Designed for vehicle, marine and outdoor installations, this charger provides protection against dust and immersion in water (IP67) and a form factor that fits into confined mounting locations.

Advantages

The charger provides a regulated 7A output at 12V with adaptable charging for both lead‑acid and lithium battery chemistries, enabling safe and efficient charging cycles. Its IP67‑rated enclosure ensures resistance to dust and temporary immersion, making it suitable for wet and dirty environments. The compact design simplifies installation in vehicles and boats, and the stable current output supports battery maintenance and extends service life when used according to manufacturer recommendations.

Suitable for

• Charging and maintaining 12V lead‑acid batteries (including AGM and GEL) where compatible
• Charging compatible 12V lithium battery systems requiring a 7A charge source
• Vehicle electrical systems, marine battery banks, and outdoor equipment with exposure to moisture

Key specifications

• Output voltage: 12V nominal
• Maximum charge current: 7A
• Enclosure protection: IP67 (dust tight and protected against temporary immersion)
• Compact, mountable housing suitable for limited spaces
• Compatible with lead‑acid and compatible lithium battery chemistries

How to use

Mount the charger in a location that allows safe cable routing and adequate ventilation. Connect the positive and negative outputs to the corresponding battery terminals, observing correct polarity. Select or confirm the charger settings appropriate for the battery chemistry in use if the unit provides selectable modes. Once connected, monitor charging until the charger indicates completion or the battery reaches the recommended float/finish voltage. Disconnect supply before performing battery maintenance or removal.

Recommendations

Use the charger with batteries that match the specified 12V system voltage and within the recommended capacity range for a 7A charger. Verify compatibility with the specific lead‑acid or lithium battery manufacturer's charging profile. Avoid installing the charger in locations with continuous submersion; IP67 permits temporary immersion but not permanent underwater use. Regularly inspect connections and cables for corrosion or wear.