ACT 1,5 m LSZH Multimode 50/125 OM2 kuitu-patchkaapeli Duplex LC- ja SC-liittimillä

The ACT Fiber Patch Cable Duplex LC SC 1.5m 50/125 OM2 is a multimode fiber jumper designed for indoor network connections. It combines LC and SC duplex connectors on a 1.5 meter LSZH jacketed fiber core with 50/125 µm geometry (OM2) to support reliable multimode transmission. The cable supports full duplex communication for simultaneous send and receive paths, and its Low Smoke Zero Halogen (LSZH) outer jacket reduces toxic fumes and corrosive gases in case of fire, making it suitable for enclosed spaces and building infrastructure.

Advantages

This fiber patch cable provides stable multimode performance with OM2 core dimensions that are compatible with common multimode transceivers and equipment. The duplex LC and SC connector pairing allows flexible interfacing between devices with different connector types without additional adapter hardware. The LSZH jacket increases safety for indoor installations, and the 1.5 meter length minimizes excess slack while allowing convenient physical routing in racks, cabinets, and patch panels.

Suitable for

• Connecting multimode transceivers and switches in data centers and server rooms
• Patch panel to switch/router connections in office networks
• Short horizontal cabling runs in structured cabling systems
• Equipment interconnects where LC and SC ports coexist

Key specifications

• Fiber type: Multimode, 50/125 µm (OM2)
• Connector configuration: Duplex LC to SC
• Cable length: 1.5 m
• Jacket material: LSZH (Low Smoke Zero Halogen)
• Supports full duplex data transmission
• Typical indoor application: patching and equipment interconnect

How to use

Route the duplex fiber cable between the two ports to be connected, ensuring the LC and SC connectors are mated with compatible receptacles. Observe proper fiber handling: avoid tight bends and excessive pulling force, keep connector end-faces clean, and use dust caps until installation. If required, secure the cable within cable management trays or patch panels to prevent strain on the connectors. After installation, verify link integrity and optical performance using appropriate test equipment or the system’s link status indicators.

Recommendations

Maintain connector cleanliness by using fiber cleaning tools before making connections, follow recommended minimum bend radius for multimode fiber, and select the cable length that minimizes slack while allowing safe routing. Use LSZH cable in enclosed public or commercial spaces where reduced smoke and halogen emissions are important for safety compliance.